Blessington Watch Manual

This guide applies to all screw down crown models.

Models covered:

Original Men's Wildlife Series

Tungsten Men's Wildlife Series

Women's Wildlife Series

Water resistance:

Original Men's Wildlife Series: 10 ATM

Tungsten Men's Wildlife Series: 20 ATM

Women's Wildlife Series: 10 ATM

Important:

The crown is the small knob on the side of the watch.

Your crown must always be screwed down tightly against the case when you are finished adjusting your watch.

If the crown is left open or not screwed down properly water can enter the watch and flood the internal movement.

Please always check your crown is fully closed before any contact with water.

How to open the crown

Hold the crown between your fingers.

Turn it anti clockwise.

Keep turning until it pops loose and springs slightly outward.

Once it pops out the crown is unscrewed and ready to use.

Crown positions

Position 0
Crown fully pushed in and screwed down. This is the normal wearing position.

Position 1
First click out. This is used to change the date.

Position 2
Second click out. This is used to change the time.

How to change the date

Step 1: Unscrew the crown by turning it anti clockwise.

Step 2: Pull the crown gently to the first click.

Step 3: Turn the crown until the correct date appears.

Step 4: Push the crown back in when finished.

How to change the time

Step 1: Unscrew the crown.

Step 2: Pull the crown gently to the second click.

Step 3: Turn the crown until the correct time is shown.

Step 4: Push the crown fully back in when finished.

How to close the crown properly

Step 1: Push the crown all the way back toward the case.

Step 2: While gently pressing inward turn the crown clockwise.

Step 3: Keep turning until the crown stops and feels tight against the case.

Your watch is only sealed once the crown is fully screwed down.

Very important water warning

If the crown is not screwed down tightly water can enter the watch.

If water enters the watch it can damage or flood the internal movement.

This is one of the most common mistakes customers make.

If you are going near water always check the crown is fully screwed down first.

Movement information

Miyota 2115

Used in the Original Men's Wildlife Series and the Women's Wildlife Series.

This movement allows you to change the time and date using the crown positions explained above.

Swiss Ronda 515

Used in the Tungsten Men's Wildlife Series.

This movement allows you to change the time and date using the crown positions explained above.

Date setting tip

Do not change the date between 9pm and 3am.

During this time the watch may already be changing the date internally.

Changing the date during this period can damage the movement.

If needed change the time first so the watch is outside this range then set the date.

Final reminder

After changing the time or date always screw the crown back down tightly.

If the crown is not fully closed water can get into the watch.

Push in. Screw down. Check it is tight.